Stiebel-eltron SOL 25 PLUS Manuel d'utilisateur télécharger pdf (Page 48)

48 | SOL 25 PLUS WWW.STIEBEL-ELTRON-USA.COM

8. As illustrated, another pivot bracket is connected to the top of the

standoff strip.

9. When installing two or more collectors, brace the center span.

When setting up four or more collectors, brace both end spans.

With six or more collectors, braces (S109) should also be placed in

an inside span.

10. The frame created from the support rails (S101) and collector

proﬁle rails is now bolted to the pivot brackets (34). The bolt located

in the channel of the proﬁle rails is bolted into the middle hole of

the pivot bracket. (Before bolting together the support rails and

proﬁle rails, two bolts must be inserted into the channel of each

proﬁle rail).

11. If more than one rooftop frame is used, mount the frames to

one another using frame connector (splice) kits (SFC001, shown in

Figure 19) to join them, as shown in Figures 18 and 20. Line up the

mounting supports with a string so that the mounting frames will be

aligned properly.

12. Then tighten all bolts and screws.

Step 01: Major components of the Stiebel

Eltron Tilt Mounting System (single panel

vertical version displayed).

Step 02: Align the mounting system

components upside down as shown. The

longer cutout surface (approx. 1”) should

be facing toward the center of the rectangle

and be parallel to the ground on both the

top and bottom. This is the surface on

which the back of the collector will rest. The

end of the support rail with the hole closer

to the edge is the top side of the rail.

5.4.1 Detailed Assembly Instructions for Tilt Mounting Kit

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 76 77

Pas de commentaire

Stiebel-eltron SOL 25 PLUS Manuel d'utilisateur Page 48