Stiebel-eltron SOL 25 PLUS Manuel d'utilisateur télécharger pdf (Page 50)

50 | SOL 25 PLUS WWW.STIEBEL-ELTRON-USA.COM

Step 06: Slide the threads of the bolt

through the hole in the top side of the of the

support rail.

Step 08: Displayed is the completed

rectangle (top view).

Step 07: Install the M10 serrated ﬂange nut.

Repeat this procedure for the remaining

three corners of the rectangle, making sure

that the top sides of the proﬁle rails are each

attached to the same proﬁle rail.

Note 1: If assembling a horizontal tilt

mounting system, there is only one hole on

either end of the diagonal support.

Note 2: If assembling a mounting system

using the longer proﬁle rails (p/n 185546)

the diagonal supports should not be

fastened to the ends of the proﬁle rails, but

should be assembled such that the supports

are approximately 2’ from each side of the

proﬁle rail and are therefore approximately

4 feet from each other.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 76 77

Pas de commentaire

Stiebel-eltron SOL 25 PLUS Manuel d'utilisateur Page 50